Power interposer board

Removing power interposer board

• Follow the safety guidelines listed in Safety instructions.

• Follow the procedure listed in Before working inside your system.

• Remove the air shroud

• Disconnect all the cables connected from the PIB to the system board.

Note:   Ensure that you note the routing of the cables as you remove them from the system board.

• Remove the PSU.

Follow the below steps to remove the Interposer Board:

1. Using a Phillips #2 screwdriver, remove the two screws securing the Power Interposer Board (PIB) to the system.

2. Lift the board and slide it out at an angle to disengage the guide pins on the board.

3. Lift the board away for the system.

Installing power interposer board

• Follow the safety guidelines listed in Safety instructions.

Follow the below steps to install the Interposer Board:

1. Align the slots on the PIB with the guides on the system.

2. Using a Phillips #2 screwdriver, replace the two screws to secure the PIB to the system.

3. Route the cables and connect it to the system board.

After installing the Interposer Board you could do the following:

1. Install the PSU.

2. Install the air shroud.

3. Follow the procedure listed in After working inside your system.